LVPS failure service check
Action Yes No
Step 1
POR the printer.
Does the error remain?
Go to step 2. The problem is solved.
Step 2
Make sure that all of the LVPS cables are properly connected.
Does the error remain?
Go to step 3. The problem is solved.
Step 3
a Replace the LVPS. See “LVPS removal” on page 445.
b POR the printer.
Does the error remain?
Go to step 4. The problem is solved.
Step 4
Replace the controller board. See
“Controller board removal” on
page 422.
Does the error remain?
Contact the next level
of support.
The problem is solved.
13y errors
13y error messages
Error code Description Action
130.01 Transfer servo error Reset the machine. If the error remains, replace the imaging
unit.
133.05 Toner Level Sensing reading above
maximum expected value
Go to
“Toner level sensing service check” on page 252.
133.06 Toner Level Sensing reading below
minimum expected value
133.07 Toner failed to replenish into the Imaging
Unit
133.08 Excessive toner level sensing noise
7463
Diagnostic information
251
To Next Page
Loading...
