ADF edge erase
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy jobs have a minimum
of a two millimeter border. Copy jobs will use the setting or two millimeters, whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1 Select ADF Edge Erase from the Configuration Menu. [setting's current value] displays.
2 Select minus to decrease the setting’s value or plus to increase the setting’s value.
3 Select Submit to save the change.
4 Select Back to cancel and return to the Configuration Menu.
Scanner Manual Registration
Use this setting to register the flatbed and ADF on the scanner. Perform a registration adjustment whenever the ADF,
flatbed, or controller board is replaced.
Note: This setting does not appear if the Disable Scanner setting is set to Auto Disabled.
Enter the Configuration Menu, and then navigate to Scanner Manual Registration.
Disable scanner
This menu item is used to disable the MFP scanner if it is malfunctioning. The MFP must be powered off and on for the
new settings to take effect.
To change this setting:
1 Select Disable Scanner from the Configuration menu.
2 Scroll through the setting's other possible values. The settings are Enable, Disable, ADF disable.
3 To save the setting's new value, select Submit.
4 Select Submit to accept the value.
Paper Prompts
This controls which tray a change prompt is directed to when paper is sensed to be the wrong size.
Note: The value of
“Action for Prompts” on page 363 may override the value of this setting.
To change this setting:
1 From the Configuration menu, navigate to Paper Prompts.
2 Select from the available options:
• Auto (default)
• Multi‑purpose Feeder
• Manual Paper
3 Depending on the printer model, press OK or touch to save the setting, or press X to return to the Configuration
menu without saving any changes.
7463
Service menus
362
To Next Page
Loading...
