3 To view the result for an ADF front adjustment, place a test page image side up and touch Copy Quick Test. Compare
the results to the original. Adjust if necessary.
4 To view the result for an ADF back adjustment, place a test page image side down and touch Copy Quick Test.
Compare the results to the original. Adjust if necessary.
5 To view the result for a flatbed adjustment, do the following:
a Remove any paper from the ADF. Compare the results to the original. Adjust as needed.
b Place a test page on the flatbed and touch Copy Quick Test.
c Compare the results to the original. Adjust if necessary.
Reset flatbed, ADF front, and ADF back calibration values
These settings revert the selected scan source IQT black and white values back to the Nominal Black and Nominal White
settings.
Perform this test only on a replacement scanner.
To reset a scanner calibration value, do the following:
1 Navigate to Diagnostics Menu > Scanner Calibration.
2 Select a calibration value to adjust.
3 Apply the changes.
PRINT TESTS
The Print Test determines whether the printer can print on media from any of the paper input sources. Each of the
installed sources is available within the Print Tests menu.
The content of the test page varies depending on the media in the selected input source:
• If the selected source contains paper, then a page similar to the Quick test page is printed, but without the print
registration diamonds.
• If the selected source contains envelopes, then an envelope print test pattern is printed. This pattern contains only
text, which consists of continuous prints of each character in the selected symbol set. If Continuous is selected,
then the envelope print test pattern is printed on the first envelope; the rest are blank.
The Print Test page always prints single-sided, regardless of the duplex setting or the presence of the duplex option.
To run the Print Test:
1 From the Diagnostics menu, navigate to PRINT TESTS.
2 Select the paper source.
3 Select any of the following:
• Single—Prints a single Print test page (No buttons are active while the Print Test Page is printing.)
• Continuous—Continuously prints the Print test pages until X is pressed
Print Quality Pages
This setting lets you view the values of a broad range of the printer settings and test the printer ability to generate an
acceptable printed output.
Enter the Diagnostics menu, and then navigate to:
7463
Service menus
338
To Next Page
Loading...
