Lexmark MX71X - Paper Jam Messages

Error code Description Action
457.89 Staple, hole punch finisher: Stapler failed to prime
after a stapling operation
Go to
“Stapler carriage (HPU) jam service check” on
page 208.
457.90 Finisher/offset stacker: Stapler failed to prime before
a stapling operation
Go to
“Stapler carriage jam service check” on
page 191.
457.90 Staple, hole punch finisher: Stapler failed to prime
before a stapling operation
Go to
“Stapler carriage (HPU) jam service check” on
page 208.
458 paper jam messages
Error code Description Action
458.41 HPU motor stalled. Go to
“HPU motor jam service check” on page
209.
458.42 HPU motor did not reach the required speed.
458.43 Took too long to ramp up HPU motor.
458.53 HPU motor went over the required speed.
459 paper jam messages
Error code Description Action
459.42 HPU feed motor did not reach the required speed. Go to
“HPU feed motor jam service check” on
page 211.
459.43 Took too long to ramp up HPU feed motor.
459.53 HPU feed motor went over the required speed.
459.71 HPU motor failed to return to its home position. Go to
“HPU motor jam service check” on page
209.
459.72 HPU home position sensor was not detected.
459.75 A communication error occurred between the HPU
and the stapler.
Go to
“HPU communication error jam service
check” on page 212.
459.81 HPU motor jammed. Go to
“HPU motor jam service check” on page
209.
459.84 Sensor (HPU media align) was blocked. Go to
“Sensor (HPU media align) jam service check”
on page 213.
459.85 Media remains detected by the sensor (HPU trailing
edge).
Go to
“Sensor (HPU trailing edge) jam service
check” on page 214.
459.86 Media remains detected by the sensor (HPU media
align).
Go to
“Sensor (HPU media align) jam service check”
on page 213.
459.87 Media fed did not reach the sensor (HPU trailing edge)
on time.
Go to
“Sensor (HPU trailing edge) jam service
check” on page 214.
459.89 The leading edge of the fed media did not reach the
sensor (HPU media align) on time after DMID.
Go to
“HPU communication error jam service
check” on page 212.
459.90 The leading edge of the fed media did not reach the
sensor (HPU media align) on time.
Go to
“Sensor (HPU media align) jam service check”
on page 213.
7463
Diagnostic information
176