Input source Empty
(Input tray empty
sensor)
Low
(Input tray paper low
sensor)
Pass through sensor
Multi‑purpose feeder
Envelope feeder
3 Manually actuate each sensor. The tray empty sensor can be actuated by hand; however, a sheet of paper can be
used to cover the pass through sensor.
4 Press X to exit the test.
OUTPUT BIN TESTS
Feed Tests
This test verifies that media can be fed to a specific output bin. No information is printed on the media.
To run the feed tests:
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Feed Tests
2 Select the output bin into which you want the paper to exit. All installed output bins appear.
3 Select one of the following:
• Single—Feeds a single page
• Continuous—Continuously feeds pages until X is pressed
Feed To All Bins
This test verifies that media can be fed to the standard bin or any installed output options. No information is printed
on the media.
To run the Feed To All Bins test:
1 From the Diagnostics menu, navigate to: OUTPUT BIN TESTS > Feed to All Bins.
The printer feeds a separate piece of media to the standard bin first, then it feeds a separate piece of media to each
output bin installed in order.
The test continuously prints the Print test pages until X is pressed.
2 Press Back to return to the OUTPUT BIN TESTS menu.
Sensor Test
This test verifies that the output bin sensors are working correctly.
7463
Service menus
345
To Next Page
Loading...
