Warning—Potential Damage: Do not tap the cartridge on a hard surface. This could damage the cartridge.
7 Push the cartridge holder firmly back into the stapler unit until the cartridge holder clicks into place.
8 Close the stapler door.
9 To clear the message and continue printing, select Next > > Clear the jam, press OK > .
451 paper jam messages
Error code Description Action
451.01 Finisher/offset stacker: Media remains detected by
the sensor (pass through) after power on.
Go to
“Sensor (finisher pass through) jam service
check” on page 177.
451.01 Staple, hole punch finisher: Media remains detected
by the sensor (pass through) after power on.
Go to
“Sensor (HPU finisher pass through) jam
service check” on page 193.
451.03 Finisher/offset stacker: The media fed did not reach
the sensor (pass through).
Go to
“Sensor (finisher pass through) jam service
check” on page 177.
451.03 Staple, hole punch finisher: The media fed did not
reach the sensor (pass through).
Go to
“Sensor (HPU finisher pass through) jam
service check” on page 193.
451.05 Finisher/offset stacker: The media while feeding
remains detected by the sensor (pass through).
Go to
“Sensor (finisher pass through) jam service
check” on page 177.
451.05 Staple, hole punch finisher: The media while feeding
remains detected by the sensor (pass through).
Go to
“Sensor (HPU finisher pass through) jam
service check” on page 193.
7463
Diagnostic information
171
To Next Page
Loading...
