Toner smear check
Actions Yes No
Step 1
Check if the fuser screws are tightly fastened.
Are they tightly fastened?
Go to step 2. Reseat the fuser, and
tighten the screws.
Step 2
Check the following fuser components for wear or damage:
• Gears
• Exit rollers
• Heat belt or hot roller
Are they free of damage?
Go to step 3. Replace the fuser. See
“Fuser removal” on
page 556.
Step 3
Check the cables on the LVPS.
Are the connections on the above component properly connected?
Contact the next level
of support.
Replace the LVPS. See
“LVPS removal” on
page 445.
Paper jams
Avoiding jams
Load paper properly
•
Make sure paper lies flat in the tray.
7463
Diagnostic information
74
To Next Page
Loading...
