To run this test:
1 From the Diagnostics menu, navigate to:
Output Bin Tests > Sensor Test > Standard Bin
Testing... appears while the printer is verifying the state of the sensor.
The control panel displays the current state of the sensor.
2 Manually actuate the sensor to make it toggle between empty and full. If the sensor does not toggle, then the
sensor is malfunctioning.
3 Press X to exit the test.
Diverter Test
This test verifies that the mailbox option’s output media diverters are working correctly. If more than one mailbox
option is installed, then this test exercises the diverters on all installed mailbox devices.
To run the Diverter Test:
1 From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Diverter Test.
Diverter Test Testing... appears while the printer is verifying the state of the diverter.
2 Press X to exit the test.
FINISHER TESTS
Staple Test
This test verifies the operation of the staple mechanism in the finisher. The printer feeds eight pieces of media to the
finisher and accumulates all eight pieces in the finisher. After the last sheets are accumulated, the pack is stapled.
To run this test:
1 Enter Diagnostics menu, and select FINISHER TESTS.
2 Select Staple Test.
Staple Test Running... appears while the test is running.
Hole Punch Test
This test verifies that media can be fed to the finisher output bin and then hole punched. The printer feeds eight pieces
of blank media to the finisher and then the pages are hole‑punched with a 2‑hole, 3‑hole, or 4‑hole pattern, depending
on the selected punch test.
To run this test:
1 From the Diagnostics menu, navigate to:
Finisher Tests > Hole Punch Test
2 Select one of the following:
• 2 Punch Test
• 3 Punch Test
7463
Service menus
346
To Next Page
Loading...
