Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
For more information, visit
http://support.lexmark.com or contact customer support.
Reattach bin [x]
Try one or more of the following:
• Turn off the printer, and then turn it back on.
• Reattach the indicated bin.
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bin.
4 Reattach the bin.
5 Connect the power cord to a properly grounded electrical outlet.
6 Turn the printer back on.
• Remove the indicated bin:
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bin.
4 Contact customer support at http://support.lexmark.com or your service representative.
• From the printer control panel, touch Continue to clear the message and print without using the specified bin.
Reattach bins [x] – [y]
Try one or more of the following:
• Turn off the printer, and then turn it back on.
• Reattach the indicated bins:
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bins.
4 Reattach the bins.
5 Connect the power cord to a properly grounded electrical outlet.
6 Turn the printer back on.
• Remove the indicated bins:
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bins.
4 Contact customer support at http://support.lexmark.com or your service representative.
From the printer control panel, touch Continue to clear the message and print without using the indicated bins.
7463
Diagnostic information
229
To Next Page
Loading...
