4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
USB port [x] disabled [56]
From the printer control panel, touch Continue to clear the message.
Notes:
• The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Weblink server not set up. Contact system administrator.
From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
User attendance messages
User attendance messages (0‑99.99)
Error
code
Description Action
10.xx Too many vinyl labels printed successively. Reduce the vinyl labels printed. Print less than
50 vinyl labels in a row, or print at least one
vinyl label per six plain paper pages.
30.xx Toner cartridge missing Make sure all cartridges are installed properly.
31.21 Toner Level Sensing reading out of range Go to
“Toner level sensing error service check”
on page 242.
31.22 Excessive toner sensing line noise Go to
“Toner level sensing error service check”
on page 242.
31.23 Abrupt change detected in toner sensing reading Go to
“Toner level sensing error service check”
on page 242.
31.25 Toner level sensing calibration capacitor reading too low Go to
“Toner level sensing error service check”
on page 242.
31.40 Toner cartridge smart chip error Go to
“Toner cartridge smart chip error service
check” on page 242.
31.41 Toner cartridge I2C packet timeout Go to
“Toner cartridge smart chip error service
check” on page 242.
31.42 Toner cartridge I2C packet has been sent but code timed-out on
receiving the data (callback)
Go to
“Toner cartridge smart chip error service
check” on page 242.
31.43 Toner cartridge security error in the send challenge sequence Go to
“Toner cartridge smart chip error service
check” on page 242.
7463
Diagnostic information
237
To Next Page
Loading...
