Jobs on Disk
This setting appears only if a hard disk is installed. It allows buffered jobs to be deleted from the disk. This does not
affect Print and Hold or parked jobs.
To change the setting:
1 From the Configuration menu, navigate to Jobs on Disk.
2 Select from the available options to change the setting:
• Delete
• Do Not Delete (default)
3 Press X to return to the Configuration menu.
Disk Encryption
Warning—Potential Damage: If the settings are changed, then the printer completely formats the hard disk. All
information on the disk will be unrecoverable.
This setting appears only if a hard disk is installed. It controls whether the printer encrypts the information that it writes
to the hard disk.
To change the setting:
1 From the Configuration menu, navigate to Disk Encryption.
2 Select from the available options to change the setting.
• Enable—enables encryption of hard disk.
• Disable (default)—enables formatting of hard disk.
3 Contents will be lost. Continue? appears. Select Yes to proceed with the encryption or formatting
of the disk, or No to cancel the operation. If Yes is selected, then a progress bar appears on the display that indicates
the overall completion of the selected operation. After completion, the display returns to Disk Encryption.
Wipe All Settings
This makes any sensitive information that may exist on the volatile or non-volatile storage of the device completely
indecipherable. When selected, the printer performs a non‑critical NVRAM reset and then reboots.
Font Sharpening
This setting allows a user to set a text point-size value below which the high‑frequency screens will be used when
printing font data.
To change the setting:
1 From the Configuration Menu, navigate to Font Sharpening.
2 To change the value, depending on the model, enter the numerical value or press the arrows, and then press
Submit.
3 Press Back or X to return to the Configuration menu.
7463
Service menus
364
To Next Page
Loading...
