Size sensing
This setting controls whether the printer automatically registers the size of paper installed in an input source with size
sourcing.
Paper source Size sensing
250‑sheet Tray X
500‑sheet Tray X
2100‑sheet Tray X
MP Feeder
Duplex
When set to Auto, a size-sensing input option automatically reports the size of media that it contains to the device.
When Off, the printer ignores the size reported by the size sensing hardware. The media size can be set by the control
panel or the data stream.
To change the size sensing setting:
1 From the Configuration menu, navigate to Size sensing.
2 Select Auto or Off, and depending on the printer model, press OK or touch .
3 Press Back or X to return to the Configuration menu.
Panel Menus
The value of this option determines whether the control panel menus are locked or available.
To run the Feed test:
1 From the Configuration menu, navigate to Panel Menus.
2 Choose one of the following:
• On—Enables control panel menus
• Off—Disables control panel menus
PPDS Emulation
The value of this option determines if a printer can recognize and use the PPDS data stream.
Available options:
• Deactivate
• Activate
Download Emuls
This appears only if at least one download emulator (DLE) is installed. The default setting is Disable. All download
emulators (DLEs) are reenabled automatically after two PORs.
7463
Service menus
359
To Next Page
Loading...
