• 4 Punch Test
Hole Punch Test Running... appears while the test is running.
Feed Test (finisher)
This test verifies that media can be fed from the default source to a finisher output bin. Any size paper that is supported
can be used. The printer feeds one blank sheet of media from the default paper source to the finisher output bins.
To run this test:
1 From the Diagnostics menu, navigate to:
Finisher Tests > Feed Test
2 Select the output bin, and press .
Feed Tests Running... appears while the test is running.
Finisher Sensor Test
This test determines if the finisher sensors are working correctly. The sensors that are tested include the following:
• Bin Level
– Finisher Bin Empty
– Bin Full sensor
– Bin Near Full
• Cover and Door
– Side Door sensor
• Pass and Media
– Finisher Passthru
– Media sensor
• Staple Sensors
– Cartridge Presence sensor
– Staple Low sensor
– Self-priming sensor
– Home Signal sensor
From the Diagnostics menu, navigate to: FINISHER TESTS > Finisher Sensor Test.
• When you select a Sensor group such as Bin Level from the menu, Bin Level Testing… appears, and the
sensors in that group are polled.
• After the sensors are polled, you can manually actuate each of the sensors. When the sensor is closed, Closed
appears; when the sensor is open, Open appears.
• To exit the sensor test, press Stop (X) or touch Back.
BASE SENSOR TEST
Use the Base Sensor Test to determine that the sensors located inside the printer are operating correctly.
7463
Service menus
347
To Next Page
Loading...
