Lexmark MX71X - Paper Jam Messages

454 paper jam messages
Error code Description Action
454.41 Finisher/offset stacker: ejector motor stalled Go to
“Finisher ejector jam service check” on
page 184.
454.41 Staple, hole punch finisher: ejector motor stalled Go to
“Finisher (HPU) ejector jam service check” on
page 200.
454.42 Finisher/offset stacker: ejector motor did not reach
the required speed.
Go to
“Finisher ejector jam service check” on
page 184.
454.42 Staple, hole punch finisher: ejector motor did not
reach the required speed.
Go to
“Finisher (HPU) ejector jam service check” on
page 200.
454.43 Finisher/offset stacker: Took too long to ramp up
ejector motor
Go to
“Finisher ejector jam service check” on
page 184.
454.43 Staple, hole punch finisher: Took too long to ramp up
ejector motor
Go to
“Finisher (HPU) ejector jam service check” on
page 200.
454.53 Finisher/offset stacker ejector motor went over the
normal speed.
Go to
“Finisher ejector jam service check” on
page 184.
454.53 Staple, hole punch finisher: ejector motor went over
the normal speed.
Go to
“Finisher (HPU) ejector jam service check” on
page 200.
454.77 Finisher/offset stacker: ejector failed to leave its
home position
Go to
“Finisher ejector jam service check” on
page 184.
454.77 Staple, hole punch finisher: ejector failed to leave its
home position
Go to
“Finisher (HPU) ejector jam service check” on
page 200.
454.78 Finisher/offset stacker: ejector failed to reach its
home position
Go to
“Finisher ejector jam service check” on
page 184.
454.78 Staple, hole punch finisher: ejector failed to reach its
home position
Go to
“Finisher (HPU) ejector jam service check” on
page 200.
455 paper jam messages
Error code Description Action
455.71 Finisher/offset stacker: diverter failed to leave its
home position
Go to
“Finisher diverter jam service check” on
page 185.
455.71 Staple, hole punch finisher: diverter failed to leave its
home position
Go to
“Finisher (HPU) diverter jam service check”
on page 201.
455.72 Finisher/offset stacker diverter failed to reach its
home position
Go to
“Finisher diverter jam service check” on
page 185.
455.72 Staple, hole punch finisher: diverter failed to reach its
home position
Go to
“Finisher (HPU) diverter jam service check”
on page 201.
455.79 Finisher/offset stacker: paddle failed to leave its
home position
Go to
“Finisher paddle jam service check” on
page 186.
455.79 Staple, hole punch finisher: paddle failed to leave its
home position
Go to
“Finisher (HPU) paddle jam service check” on
page 202.
7463
Diagnostic information
173