Lexmark MX71X - Paper Jam Messages

3 Close the rear door.
4 To clear the message and continue printing, select Next > > Clear the jam, press OK > .
202 paper jam messages
Error code Description Action
202.01 Media remains on the sensor (narrow media)
during the warm‑up sequence (MS71x).
Go to
“Sensor (narrow media) static jam service check” on
page 99.
202.01 Media remains on the sensor (fuser exit)
during the warm‑up sequence.
Go to
“Sensor (fuser exit) static jam service check” on page
95.
202.03 The media is late reaching the sensor (fuser
exit) within the specified time.
Go to
“Sensor (fuser exit) late-arriving jam service check” on
page 97.
202.05 The media reached the sensor (fuser exit) but
did not clear it within the specified time.
Go to
“Sensor (fuser exit) late-leaving jam service check” on
page 96.
202.07 The media reached the sensor (fuser exit) but
did not clear it within the specified time.
Go to
“Sensor (fuser exit) late-leaving jam service check” on
page 96.
202.13 The media is late reaching the sensor (fuser
exit) within the specified time.
Go to
“Sensor (fuser exit) late-arriving jam service check” on
page 97.
202.14 Expected banner sheet (assumed wide) not
detected by narrow media sensor—possible
accordion jam, unsupported narrow banner
media, or missing signal.
Go to
“Sensor (narrow media) late arriving jam service check”
on page 98.
202.16 Page at fuser nip before fuser started
ramping toward desired area. Indicates code
may be receiving more hall interrupts than
intended.
Go to
“Fuser drive motor control jam service check” on page
91.
202.17 Page at fuser nip before fuser reached
acceptable operating temperature. Page
arrived at fuser earlier than expected, so it
was probably staged.
Go to
“Fuser drive motor control jam service check” on page
91.
7463
Diagnostic information
94