Action Yes No
Step 3
Check the path between the sensor (bin full receive) and the sensor (bin
full send).
Is it free of obstructions?
Go to step 4. Clear the obstructions
between the two
sensors. Remove dirt
on the sensor covers.
Make sure the sensor
covers are stable and
properly installed; both
sensors should be
visible when viewed
through the sensor
covers.
Step 4
Open the left cover. Without disconnecting the cables, remove the
controller board to access the sensor underneath. Reseat the cable J9 on
the controller board and reseat the connector on the sensor end. POR the
machine.
Does the error remain?
Go to step 5. The problem is solved.
Step 5
Check the sensor (bin full receive) and sensor (bin full send). Reinstall the
sensors and make sure they are correctly aligned.
Are the sensors free of damage?
Go to step 6. Replace the sensor (bin
full receive) and the
sensor (bin full send).
Go to
“Sensor (bin full
receive) removal” on
page 763 and “Sensor
(bin full send)
removal” on page
762.
Step 6
Check the output bin elevator:
• Manually push the elevator down and check if it goes back to its home
position when released.
• Check the elevator springs if they are not dislodged or misaligned.
Is the component functional and free of damage?
Go to step 7. Replace the staple
finisher assembly. Go
to
“Staple finisher/
offset stacker option
removal” on page
723.
Step 7
Open the left cover, reseat all connectors on the controller board and then
POR the machine.
Does the error remain?
Replace the controller
board. Go to
“Stapler/
offset stacker
controller board
removal” on page
756.
If the error persists,
then replace the staple
finisher. Go to
“Staple
finisher/offset stacker
option removal” on
page 723.
The problem is solved.
7463
Diagnostic information
322
To Next Page
Loading...
