Learning Advanced Features
Output is based on the output value of the
external PID1 controller. Outputs 10 V in 100%.
Output is based on the reference value of the
external PID1 controller. Outputs 6.6 V in 100%.
Output is based on the feedback amount of the
external PID1 controller. Outputs 6.6 V in 100%.
OUT-02 AO1
Gain,
OUT-03 AO1
Bias
Adjusts output value and offset. If frequency is selected as an output item,
it will operate as shown below.
The graph below illustrates how the analog voltage output (AO1) changes
depending on OUT-02 (AO1 Gain) and OUT-3 (AO1 Bias) values. The Y-
axis is analog output voltage (0–10 V), and the X-axis is a % value of the
output item.
Example, if the maximum frequency set at DRV-20 (Max Freq) is 60 Hz
and the present output frequency is 30 Hz, then the x-axis value on the
next graph is 50%.
Set filter time constant on analog output.
If the analog output at OUT-01 (AO1 Mode) is set to ‘12 (Constant)‘, the
analog voltage output is dependent on the set parameter values (0–
To Next Page
Loading...
