LSIS LSLV0055H100-4COFN - Page 323

309
Learning Advanced Features
Code
Description
31
PumpClean
Sel
Outputs a signal when a pump cleaning function is in
operation.
32
LDT Trip
Outputs a signal when an LDT trip occurs.
33
Damper
Control
Outputs a signal when a damper open signal is set at
IN-65–71 multi-function terminals and run command is
on.
34
CAP.Warnin
g
Outputs a signal when value of the PRT-85 is lower
than the value of the PRT-86 (CAP life cycle
examination do not operate properly).
35
Fan
Exchange
Outputs a signal when fan needs to be replaced.
36
AUTO State
Outputs a signal in AUTO mode.
37
HAND
State
Outputs a signal in HAND mode.
38
TO
Outputs a signal at pulse output.
39
Except Date
Outputs a signal when operating the exception day
schedule.
40
KEB
Operating
Outputs a signal at KEB operation.
41
BrokenBelt
Outputs a signal when a Broken belt is in operation.
OUT-36 Q1
Define
Select an output item for the multi-function output terminal (Q1) of the terminal
block. Q1 stands for the open collector TR output.
OUT-41
DO State
Used to check On/Off state of the D0 by each bit.
• FDT-1 and FDT-2 functions are related to the frequency setting of the inverter. If the inverter
enters standby mode by pressing the off key during auto mode operation, FDT-1 and FDT-2
function operation may be different because the set frequency of the inverter is different
compared to the set frequency of the auto mode.
• If monitoring signals such as ‗Under load‘ or‘ LDT‘ are configured at multi-function output
terminals, signal outpouts are maintained unless certain conditions defined for signal cutoff
are met.