Learning Advanced Features
Outputs a signal at operation command off, and when
there is no inverter output voltage.
Outputs a signal in steady operation.
Outputs a signal while the motor is driven by the
inverter line.
Outputs a signal when multi-function input terminal
(switching) is entered. For details, refer to 5.31Supply
Power Transition page on 246.
Outputs a signal during inverter speed search
operation.
For details, refer to 5.27Speed Search Operation on
page 236.
Outputs a signal when the inverter is in stand by mode
and ready to receive external operation commands.
Used as a multi-motor control function. By configuring
the relay output and the multi-function output to MMC
and configuring the AP1-40–AP1-92, it can conduct the
necessary operations for multi-motor control function.
A timer function to operate terminal output after a
certain time by using multi-function terminal block input.
For details, refer to 5.43Timer Settings on page 259.
Outputs a signal after a fault trip.
Refer to 5.45 Multi-function Output On/Off Control on
page 259 .
Refer to 0
Dynamic Braking (DB) Resistor Configuration on page
295.
Outputs a signal using an analog input value as a
standard.
Refer to 5.45 Multi-function Output On/Off Control on
page 259 .
Outputs a signal when Fire mode is in operation.
Outputs a signal when a pipe is broken.
Outputs a signal when damper open signal is not
entered. For more details, refer to 0
Damper Operation on page 188.
Outputs a signal when a lubrication function is in
operation.
To Next Page
Loading...
