7.24. Flash Command
This page describes the syntax and how to use the flash command.
To go to the flash command, press Flash on the console.
Description
With the flash command you set all values from the first cue and the dimmer attribute of an executor, temporary to
100 %, as long as you press and hold the executor button.
The flash command ignores all cue timings and individual timings.
Syntax
To set the dimmer attribute to 100 %.
Flash
Example
Let´s assume you will temporary set the dimmer attribute of executor 3 to 100 % as long as you press and hold the
executor.
There are two ways to do this:
a) If you did not change the default functions of the executor buttons, you can just press of executor 3.
b) Press Flash and press and hold the respective executor button .
As long as you hold the executor button, the flash command will be executed.
As soon as you leave the executor button, the executor is back in its previous status.
Related Links
Flash Key
Executor Flash
Change Functions of Executor Buttons
7.25. Full Command
This page describes the syntax and how to use the full command.
If you type the full command in the console, by press the Full key, the command will be directly
executed.
You can also use the command line along with the virtual keyboard and type the word full in.
To go to the full command, press Full on the console.
The full command will be directly executed.
Description
To Next Page
Loading...