Description
With the full command you set the intensity to 100 %
of the current selected fixtures
of a selection of fixtures
of an executor
Syntax
1. Set the intensity of the current selected fixtures to 100 %.
Full
2. Set the intensity of a selection of fixtures to 100 %.
Fixture 1 Thru 3 Full
3. Set the intensity of an executor to 100 %.
Executor 1 Full
Example 1
Let´s assume you will set the intensity of the current selected fixtures to 100 %.
Press Full .
The full command will be directly executed.
The values of the selected fixtures are set to 100 % and they are active in the programmer.
Double check the executed command in the command history.
Example 2
Let´s assume you will set the intensity of the fixtures 1 thru 3 to 100 %.
Make sure, that no fixtures are selected. If fixtures are selected, the full command will be always execute
to all selected fixtures.
Press Fixture 1 Thru 3 Full .
To Next Page
Loading...