MacDon R113 - Installing Cutterbar Deflectors

OPERATION
1. Raise mower conditioner fully, shut down tractor, and
remove key from ignition.
2. Close lift cylinder lock-out valves.
3. Clean debris from deflectors and deflector area.
IMPORTANT:
Do NOT remove plug (B).
4. Remove three bolts (C) securing deflector (A) to
cutterbarusingan8mmhexkeyanda16mmsocket
and remove deflector.
5. Repea t for other deflector.
6. Store d eflectors and hardware in a safe place.
Figure 3.120: Left Cutterbar Deflector Viewed
from Underside of Cutterbar
Installing Cutterbar Deflectors
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
1. Raise mower conditioner fully, shut down tractor, and
remove key from ignition.
2. Close lift cylinder lock-out valves.
3. Clean deb ris from ledge and the six moun ting holes
along aft edge of cutterbar.
4. Position left deflector (A) (with cut-out for cutterbar
drain plug (B)) on top of ledge along the aft end of the
cutterbar, and align existing fasteners and cutterbar
plug with slots in deflector (A).
5. Install three button hex head socket M10 bolts (C) with
lock nuts in the holes with the heads facing down.
Figure 3.121: Left Cutterbar Deflector Viewed
from Underside of Cutterbar
147910 98 Revision A