OPERATION
3.18 Unplugging the Mower Conditioner
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop tractor engine and remove
key before removing plugged material from mower conditioner.
1. Stop forward movement of the tractor and stop the power take-off (PTO).
2. Raise the mower conditioner fully, shut down the tractor engine, and remove the key.
3. Engage lift cylinder lock-out valves. Refer to 3.1.1 Engaging Locks, page 31.
WARNING
Wear heavy glo
ves when working around cutterbar.
4. Open cutterba
rdoors. Referto3.3.1 Opening
Cutterbar Doo
rs, page 36.
5. Clean off cutt
erbar or rolls by hand.
Figure 3.127: Cutterbar Doors
147910 105 Revision A
To Next Page
Loading...
