MacDon R113 - Index

Index
180-degree turns ................................................. 64
A
accelerators
inspecting ...................................................... 159
installing ........................................................ 160
maintaining .................................................... 159
removing ....................................................... 159
angles
cutterbar angle................................................. 82
adjusting angle
hydraulic ................................................... 82
mechanical ................................................ 82
API
definitions ........................................................ 23
ASTM
definitions ........................................................ 23
attaching mower conditioner to the tractor ............. 43
attaching with two-point hitch .......................43, 45
connecting electrical wiring harness................... 49
connecting hydraulics ....................................... 47
attachments, See options and attachments
avoiding obstacles ............................................... 63
B
belts
condit
ioner drive belt
inspec
ting................................................... 205
instal
ling..................................................... 207
remov
ing .................................................... 206
bevel
gearboxes, See gearboxes
break
in inspections ............................................113
break
ing in mower conditioners
perio
d.............................................................. 57
C
center-link
definitions ........................................................ 23
clutch drivelines, See drivelines
component identification....................................... 25
conditioner drive belts, See belts
conditioner drive gearboxes, See gearboxes
conditioners
finger conditioner ..................................... 229, 231
See also finger conditioners
See also finger conditioners
roll conditioner ............................................... 228
inspecting................................................... 228
type of conditioning
finger-type, See finger conditioner
roll-type, See ro ll condition ing
conditioning ....................................................... 228
connections
connecting electrical wiring harnesses ............... 49
connecting hydraulics ....................................... 47
conversion charts .............................................. 272
curtains............................................................. 151
door curtains
installing ..................................................... 153
removing .................................................... 152
inboard curtains
installing ..................................................... 155
removing .................................................... 154
inspecting curtains.......................................... 151
outboard curtains
installing ..................................................... 157
removing .................................................... 156
cutterbar doors
export latches
opening........................................................ 36
cutterbars.......................................................... 127
See a lso acce lerators
See also deflectors
See also deflectors
See also spindle shear pins
adjusting cutterbar angle ................................... 82
crop stream.................................................... 141
changing 13-foot configuration ..................... 142
changing 16-foot configuration ..................... 144
cutterbar doors .......................................... 36, 150
closing ......................................................... 38
inspecting................................................... 151
opening........................................................ 36
cutterblades
inspecting................................................... 145
lubricating...................................................... 127
checking lubricant level ............................... 127
draining cutterbar........................................ 129
filling cutterbar ............................................ 130
maintaining cutterbar discs.............................. 130
inspecting discs .......................................... 131
installing discs ............................................ 132
removing discs............................................ 131
cutterblades ...................................................... 145
inspecting cutterblade hardware...................... 147
installing cutterblades ..................................... 149
removing cutterblades .................................... 148
cutting heights ..................................................... 83