MAINTENANCE AND SERVICING
3. Wipe grease fitting with a cle an cloth b e fo re greasing to avoid injecting dirt and grit.
4. Inject grease through fitting with grease gun until grease overflows fitting (except where noted).
5. Leave excess grease on fitting to keep out dirt.
6. Replace an y lo ose or broken fittings immediately.
7. Remove and thoroughly clean any fitting that will not take grease. Also clean lubricant passageway. Replace
fitting if necessary.
8. Use clean high temperature extreme pressure grease only.
147910 116 Revision A
To Next Page
Loading...
