Mazda Mazda6 - Koeo;Koer Self-Test

F2–26
ON-BOARD DIAGNOSTIC
End Of Sie
KOEO/KOER SELF-TEST
A6E407018881203
KOEO/KOER self-test function table
×: Applicable –: Not applicable
End Of Sie
P0610 Control module vehicle options error PCM data configuration error. ××
P0661 VSC solenoid valve circuit low input
Input voltage from VSC solenoid valve is below 0.1
V.
– ×
P0662 VSC solenoid valve circuit high input Input voltage from VSC solenoid valve is above B+. – ×
P0850 Neutral switch circuit malfunction
Input voltage from neutral switch does not change
when vehicle stops after accelerating to above 60
km/h {37 mph} and decelerating to 0 km/h {0 mph}
2 times.
××
P1190 Calibration resistor circuit malfunction
Input voltage from calibration resistor is below 0.2 V
or above 4.8 V.
××
P2228 BARO sensor circuit low input Input voltage from BARO sensor is below 0.7 V. ××
P2229 BARO sensor circuit high input Input voltage from BARO sensor is above 4.5 V. ××
U0073 CAN bus off CAN controller is damaged. – ×
U0121
PCM cannot receive any signals from
ABS, ABS/TCS or DSC HU/CM
PCM cannot receive any signals from ABS, ABS/
TCS or DSC HU/CM.
××
U0155
PCM cannot receive any signals from
instrument cluster
PCM cannot receive any signals from instrument
cluster.
××
DTC Condition Detection condition MIL
Memory
function
DTC Condition KOEO KOER
P0097 IAT sensor No.1 circuit low input ××
P0098 IAT sensor No.1 circuit high input ××
P0102 MAF sensor circuit low input ××
P0103 MAF sensor circuit high input ××
P0107 Boost sensor circuit low input ××
P0108 Boost sensor circuit high input ××
P0112 IAT sensor No.2 circuit low input ××
P0113 IAT sensor No.2 circuit high input ××
P0117 ECT sensor circuit low input ××
P0118 ECT sensor circuit high input ××
P0122 Accelerator position sensor No.1 circuit low input ××
P0123 Accelerator position sensor No.1 circuit high input ××
P0222 Accelerator position sensor No.2 circuit low input ××
P0223 Accelerator position sensor No.2 circuit high input ××
P0602 PCM programming error ××
P0610 Control module vehicle options error ××
P0661 VSC solenoid valve circuit low input ××
P0662 VSC solenoid valve circuit high input ××
P2228 BARO sensor circuit low input ××
P2229 BARO sensor circuit high input ××
U0073 CAN bus off ××
U0121 PCM cannot receive any signals from ABS, ABS/TCS or DSC HU/CM ××
U0155 PCM cannot receive any signals from instrument cluster ××