REAR DIFFERENTIAL
M–51
M
REAR DIFFERENTIAL REMOVAL/INSTALLATION
A6E631927100207
1. Drain the rear differential oil into a container.
2. Remove the after silencer, presilencer, and catalytic converter. (See F1–30 EXHAUST SYSTEM REMOVAL/
INSTALLATION.)
3. Remove the propeller shaft. (See L–5 PROPELLER SHAFT REMOVAL/INSTALLATION.)
4. Remove the rear drive shaft. (See M–43 REAR DRIVE SHAFT REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Add the specified rear differential oil.
.
SEALANT
5
3
1
2
6
86.2—116.6
{8.8—11.9,
63.6—85.9}
74.5—104.9
{7.6—10.6, 55.0—77.3}
43.1—60.8
{4.4—6.1,
31.8—44.8}
22.6—26.4
{2.4—2.6,
16.7—19.4}
4
N·m {kgf·m, ft·lbf}
A6E63192201
1 Differential oil temperature sensor connector
2 4WD solenoid connector
3 Coupling component and rear differential
component
(See M–52 Coupling Component and Rear
Differential Component Removal/installation Note)
4 Rear differential bracket
5 Coupling component
(See M–68 COUPLING COMPONENT REMOVAL/
INSTALLATION)
6 Rear differential
To Next Page