Mazda Mazda6 - Dtc Confirmation Procedure; On-Board Diagnostic; On-Board Diagnostic Test

ON-BOARD DIAGNOSTIC
F2–85
F2
ON-BOARD DIAGNOSTIC TEST
A6E407018881206
DTCs Retrieving Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect the WDS or equivalent to the vehicle
DLC-2 16-pin connector.
3. Retrieve DTC using the WDS or equivalent.
PID/DATA Monitor and Record Procedure
1. Perform the necessary vehicle preparation and
visual inspection.
2. Connect the WDS or equivalent to the vehicle
DLC-2 16-pin connector.
3. Access and monitor PIDs using the WDS or
equivalent.
End Of Sie
DTC CONFIRMATION PROCEDURE
A6E407018881207
End Of Sie
ON-BOARD DIAGNOSTIC
DLC-2
A6E40702001
DLC-2
A6E40702001
STEP INSPECTION ACTION
1 RECORD CONTINUOUS MEMORY DTC
• Turn engine switch to ON (Engine OFF).
• Retrieve all stored DTCs using WDS or
equivalent.
• Are there any DTCs present?
Yes Record all stored DTCs (continuous memory DTC), then go
to next step.
No Go to next step.
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Information
availability.
• Is any related repair information available?
Yes Perform repair or diagnosis according to available Service
information.
• If vehicle is not repaired, go to next step.
No Go to next step.
3 PERFORM KOEO SELF-TEST
• Start engine.
• Warm up engine completely.
• Turn off all electrical loads.
• Perform KOEO SELF-TEST PROCEDURE.
(See F2–86 KOEO/KOER SELF-TEST
PROCEDURE)
• Are there any KOEO DTCs present?
Yes Repair KOEO DTC.
(See F2–87 DTC TABLE)
No Go to next step.
4 PERFORM KOER SELF-TEST
• Start engine.
• Perform KOER SELF-TEST PROCEDURE.
(See F2–86 KOEO/KOER SELF-TEST
PROCEDURE)
• Are there any KOER DTCs present?
Yes Repair KOER DTC.
(See F2–87 DTC TABLE)
No • If continuous memory DTC is present at Step 1, return
to applicable DTC troubleshooting procedure step.
• If continuous memory DTC is not present at Step 1, go
to symptom troubleshooting.