ON-BOARD DIAGNOSTIC
K2–127
K2
DTC P0705
A6E577018901205
Diagnostic procedure
DTC P0705 Transaxle range (TR) switch circuit malfunction (short circuit)
DETECTION
CONDITION
• Two or more range signals are input from TR switch for 5 seconds or more.
Diagnostic support note:
• This is a continuous monitor (CCM).
• MIL illuminates if TCM detects the above malfunction conditions in two consecutive drive cycles.
• PENDING CODE is available above malfunction condition during first drive cycle.
• FREEZE FRAME DATA is available.
• AT warning light indication.
• DTC is stored in TCM memory.
POSSIBLE
CAUSE
• TCM malfunction.
• Short to power between TR switch terminal A and TCM terminal 2B
• Short to power between TR switch terminal E and TCM terminal 1W
• Short to power between TR switch terminal D and TCM terminal 1T
• Short to power between TR switch terminal G and TCM terminal 1Z
• Damaged connector between TR switch and TCM
• TR switch malfunction
STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME PID DATA been
recorded?
Yes Go to next step.
No Record FREEZE FRAME PID DATA on repair order, then
go to next step.
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Bulletins and/or on-
line repair information availability.
• Is any related repair information available?
Yes Perform repair or diagnosis according to available repair
information.
• If vehicle is not repaired, go to next step.
No Go to next step.
TR SWITCH
TCM
TR SWITCH
HARNES SIDE CONNECTOR
TCM HARNES SIDE CONNECTOR
IG SWITCH
P
A
C
2B
1W
1T
1Z
E
D
G
R
N
D
To Next Page