K2–128
ON-BOARD DIAGNOSTIC
End Of Sie
3 VERIFY CURRENT INPUT SIGNAL STATUS-IS
CONCERN INTERMITTENT OR CONSTANT?
• Connect volt meter to TCM.
• Turn ignition key to ON (engine OFF).
• Inspect TCM terminal voltages.
(See K2–90 TCM INSPECTION.)
— TCM terminal 2B
• P position: B+
• Other positions and all ranges: 0V
— TCM terminal 1W
• R position: B+
• Other positions and all ranges: 0V
— TCM terminal 1T
— N position: B+
— Other positions and all ranges: 0V
— TCM terminal 1Z
• D range: B+
• Other ranges and all positions: 0V
• Are two or more of following terminal voltage at
the same time when shifting selector lever from
P position to D range?
Yes Go to next step.
No Go to intermittent concern troubleshooting procedure.
(See section F1.)
4 INSPECT TR SWITCH CONNECTOR
• Turn ignition key OFF.
• Disconnect TR switch connector.
• Inspect bent terminals of pins using mirror.
• Are TR switch terminals okay?
Yes Go to next step.
No Repair terminals or replace TR switch, then go to Step 8.
(See K2–81 TRANSAXLE RANGE (TR) SWITCH
REMOVAL/INSTALLATION.)
5 INSPECT TR SWITCH CIRCUIT MALFUNCTION
• Connect voltmeter to TCM.
• Turn ignition key to ON (engine OFF).
• Does TCM terminal voltage change from B+ to
0V when TR switch connector is disconnected?
Yes Go to next step.
No Go to Step 7.
6 INSPECT TR SWITCH CONTINUITY
• Turn ignition key to OFF.
• Disconnect TR switch connector.
• Inspect TR switch for continuity in positions/
ranges failed in Step 4.
• Is there continuity between TR switch terminals
(part side)?
(See K2–80 TRANSAXLE RANGE (TR) SWITCH
INSPECTION.)
Yes Go to Step 8.
No Replace TR switch, then go to Step 8.
(See K2–81 TRANSAXLE RANGE (TR) SWITCH
REMOVAL/INSTALLATION.)
7 INSPECT TR SWITCH CIRCUIT FOR SHORT TO
POWER
• Turn ignition key to ON (engine OFF).
• Measure voltage at TR switch terminal A, E, D,
G, I, and F (harness-side).
• Is there 0 V at TR switch harness side
connector?
Yes Go to next step.
No Repair or replace wiring, then go to next step.
8 VERIFY TROUBLESHOOTING OF DTC P0705
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from memory using WDS or
equivalent.
• Turn ignition key to on (engine off).
• Drive vehicle in each range (P, R, N, and D) for
5 seconds or more.
• Is same DTC present?
Yes Replace TCM, then go to next step.
(See K2–96 TCM REMOVAL/INSTALLATION.)
No Go to next step.
9 VERIFY AFTER REPAIR PROCEDURE
• Perform “After Repair Procedure”.
(See K2–124 AFTER REPAIR PROCEDURE.)
• Is there any DTC present?
Yes Go to applicable DTC inspection.
No Troubleshooting completed.
STEP INSPECTION ACTION
To Next Page