STARTING SYSTEM
G–11
G
STARTER INSPECTION
A6E471418400203
MZR-CD (RF Turbo)
On-vehicle Inspection
1. Verify that the battery is fully charged.
• Charge if necessary. (See G–6 BATTERY RECHARGING.)
2. Crank the engine and verify that the starter rotates smoothly without any noise.
• If not as specified, inspect the following:
— Remove the starter, and inspect the magnetic switch and the starter.
— Inspect the related wiring harness and the engine switch.
No Load Test
1. Verify that the battery is fully charged.
• Charge if necessary. (See G–6 BATTERY RECHARGING.)
2. Connect the starter, battery, voltmeter and
ammeter as shown.
3. Operate the starter and verify that it rotates
smoothly.
4. Measure the voltage and current while the starter
is operating.
• If not as specified, replace the starter.
Specification
End Of Sie
Voltage (V) 11
Current (A) Below 130
ENGINE
SWITCH
TERMINAL S
B
M
STARTER
V
A
VOLTMETER
BATTERY
AMMETER
A6E4714W101
To Next Page