EasyManua.ls Logo

Mazda Mazda6 - Intake Shutter Solenoid Valve Inspection

Mazda Mazda6
909 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EMISSION SYSTEM
F2–63
F2
INTAKE SHUTTER SOLENOID VALVE INSPECTION
A6E401613937201
Note
• Perform the following inspection only when directed.
• The inspection includes both intake shutter solenoid valve (half) and intake shutter solenoid valve (full).
1. Inspect airflow between the ports under the following conditions.
• If not as specified, replace the intake shutter solenoid valve.
• If as specified, carry out the “Circuit Open/Short Inspection”.
Intake Shutter Solenoid Valve (Half) Circuit Open/
Short Inspection
1. Disconnect the PCM connector. (See F2–64 PCM
REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for an open
or short circuit (continuity check).
Open circuit
• If there is no continuity, the circuit is open. Repair
or replace the harness.
— Intake shutter solenoid valve (half) terminal A
(harness-side) and PCM control relay
terminal C (harness-side)
— Intake shutter solenoid valve (half) terminal B
(harness-side) and PCM terminal 74
Short circuit
• If there is continuity, the circuit is shorted. Repair or replace the harness.
— Intake shutter solenoid valve (half) terminal A (harness-side) and GND
— Intake shutter solenoid valve (half) terminal B (harness-side) and power supply
Intake Shutter Solenoid Valve (Full) Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See F2–64 PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for an open
or short circuit (continuity check).
Open circuit
• If there is no continuity, the circuit is open. Repair
or replace the harness.
— Intake shutter solenoid valve (full) terminal A
(harness-side) and PCM control relay
terminal C (harness-side)
— Intake shutter solenoid valve (full) terminal B
(harness-side) and PCM terminal 100
Short circuit
• If there is continuity, the circuit is shorted. Repair or replace the harness.
— Intake shutter solenoid valve (full) terminal A (harness-side) and GND
— Intake shutter solenoid valve (full) terminal B (harness-side) and power supply
End Of Sie
B
A
C
B
A
A6E40162024
Step
Terminal
C
B
A
BA
Port
: Airflow
1
2
B+ GND
: Continuity
A6E40162023
INTAKE SHUTTER SOLENOID
VALVE (HALF)
HARNESS SIDE CONNECTOR
FUSE BOX
(PCM CONTROL RELAY)
B
A
A
E
C
D
A6E40162010
INTAKE SHUTTER SOLENOID
VALVE (FULL)
HARNESS SIDE CONNECTOR
FUSE BOX
(PCM CONTROL RELAY)
B
A
A
C
D
E
A6E40162011

Table of Contents