EasyManua.ls Logo

Mazda Mazda6 - Dtc P0121

Mazda Mazda6
909 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ON-BOARD DIAGNOSTIC
F2–115
F2
DTC P0121
A6E407001082216
Diagnostic procedure
DTC P0121 Accelerator position sensor No.1 circuit performance problem
DETECTION
CONDITION
• PCM monitors input voltage from accelerator position sensor No.1 while engine is running. If input voltage
from accelerator position sensor No.1 is above 1.3 V when accelerator pedal is depressed, PCM
determines accelerator position sensor No.1 circuit performance problem.
POSSIBLE
CAUSE
• Accelerator position sensor No.1 malfunction
• Connector or terminal malfunction
• Voltage drops in GND circuit
• Accelerator position sensor misadjustment
• PCM malfunction
ACCELERATOR POSITION SENSOR NO.1
4
90
10
91
PCM
DCB
A
91
90
10
A
B
D
3
5
2
2
2
5
5
ACCELERATOR POSITION SENSOR
HARNESS SIDE CONNECTOR
PCM
HARNESS SIDE CONNECTOR
STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Information
availability.
• Is any related repair information available?
Yes Perform repair or diagnosis according to available Service
Information.
• If vehicle is not repaired, go to next step.
No Go to next step.
2 INSPECT POOR CONNECTION OF
ACCELERATOR POSITION SENSOR NO.1
CONNECTOR
• Turn engine switch to OFF.
• Inspect for poor connection (damaged, pulled-
out terminals, corrosion, etc.).
• Is there any malfunction?
Yes Repair or replace suspected terminal, go to Step 6.
No Go to next step.
3 INSPECT ACCELERATOR POSITION SENSOR
NO.1 GND CIRCUIT FOR VOLTAGE DROP
• Turn engine switch to OFF.
• Inspect resistance between accelerator
position sensor terminal D and body GND.
• Is resistance approx. 0 ohm?
Yes Go to next step.
No Repair or replace suspected terminal, go to Step 6.
4 INSPECT ACCELERATOR POSITION SENSOR
NO.1
• Inspect accelerator position sensor No.1.
(See F2–72 ACCELERATOR POSITION
SENSOR INSPECTION)
• Is there any malfunction?
Yes Adjust or replace accelerator position sensor, go to Step 6.
(See F2–73 ACCELERATOR POSITION SENSOR
ADJUSTMENT)
(See F2–44 ACCELERATOR PEDAL COMPONENT
DISASSEMBLY/ASSEMBLY)
No Go to next step.

Table of Contents