SHIFT MECHANISM
J2–13
J2
Select Cable Installation Note
1. Remove the center console.
2. Make sure that the shift lever (transaxle side) is in neutral.
3. Unlock the lock pice of the select cable (shift lever
side) in the order shown in the figure.
4. Shift the sift lever to neutral.
5. Lock the lock pice of the selector cable (shift
cable side) in the order shown in the figure.
6. Install the center console.
7. Shift the shift lever from neutral to other position,
and make sure that there are no other
components in that area to interfere with the
lever.
End Of Sie
LOCK PIECE
SAFETY
LOCK
1
2
A6E5214W002
LOCK PIECE
SAFETY
LOCK
2
1
A6E5214W003
To Next Page