CYLINDER HEAD GASKET
B2–19
B2
Cylinder Head Installation Note
1. Measure the length of each cylinder head bolt.
• Replace any that exceeds maximum length.
Length
159.7—160.3 mm {6.288—6.311 in}
Maximum
161.0 mm {6.338 in}
2. Tighten the bolts in two or three steps in the order
shown.
Tightening torque
29 N·m {3.0 kgf·m, 22 ft·lbf}
3. Put a paint mark on each bolt head.
4. Using the marks as a reference, tighten the bolts
by turning each 90°—105° in the sequence
shown.
5. Further tighten each bolt by turning another
90°—105°.
6. Then further tighten each bolt by turning another
90°—105°.
Rocker Arm and Rocker Arm Shaft Installation Note
1. Apply sealant as shown in the figure.
Thickness
2 mm {0.079 in}
2. Install the camshaft caps according to the cap
number.
LENGTH
A6E2318W108
9 8
7
5 4
3
10
6
1
2
ENGINE
FRONT
A6E2318W109
29 N·m
{3.0 kgf·m, 22 ft·lbf}
SECOND
PAINT MARK
FIRST THIRD
90 105
90 105
90 105
—
—
—
A6E2318W110
SEALANT
SEALANT
SEALANT
A6E2318W111
To Next Page
Loading...
