AUTOMATIC TRANSAXLE
K2–91
K2
Terminal Signal Connected to Test Condition Voltage (V) Action
1A ———— —
1B TFT sensor
(GND)
TFT sensor Constant Continuity • Inspect TFT sensor
(See K2–84
TRANSAXLE FLUID
TEMPERATURE (TFT)
SENSOR INSPECTION)
• Inspect related harness
1C GND GND Constant Below 1.0 • Inspect related harness
1D ———— —
1E ———— —
1F TFT sensor TFT sensor ATF temperature
20 °C {68 °F}
Approx. 1.55 • Inspect TFT sensor
(See K2–84
TRANSAXLE FLUID
TEMPERATURE (TFT)
SENSOR INSPECTION)
• Inspect related harness
ATF temperature
60 °C {140 °F}
Approx. 0.7
1G K-LINE PCM Because this
terminal is for serial
communication,
good/no good
judgment by
terminal voltage is
not possible. Carry
out inspection
according to DTCs.
— • Inspect related harness
1H Cruise control
switch
Cruise control
switch
Cruise control
switch ON
B+ • Inspect cruise control
switch
(See section T)
• Inspect related harness
Cruise control
switch OFF
0
1I ———— —
1J ———— —
1K Intermediate sensor Intermediate sensor Vehicle stop 0 • Inspect Intermediate
sensor
(See K2–86
INTERMEDIATE
SENSOR INSPECTION)
• Inspect related harness
Vehicle speed at 20
km/h {12.4 mph} or
more
Above 1.0
1M VSS VSS Vehicle stop 0 • Inspect VSS
(See K2–87 VEHICLE
SPEEDOMETER
SENSOR (VSS)
INSPECTION)
• Inspect related harness
Vehicle speed at 20
km/h {12.4 mph} or
more
Above 1.0
1N Input/turbine speed
sensor
Input/turbine speed
sensor
Vehicle stop 0 • Inspect Input/turbine
speed sensor
(See K2–85 INPUT/
TURBINE SPEED
SENSOR INSPECTION)
• Inspect related harness
Vehicle speed at 20
km/h {12.4 mph} or
more
Above 1.0
AMJ5814W078
To Next Page