AUTOMATIC TRANSAXLE
K2–93
K2
2E ———— —
2F Input/turbine speed
sensor
(GND)
Input/turbine speed
sensor
Constant 0 • Inspect Input/turbine
speed sensor
(See K2–85 INPUT/
TURBINE SPEED
SENSOR INSPECTION)
• Inspect related harness
2G Reduction timing
solenoid valve
Reduction timing
solenoid valve
N position 0 • Inspect reduction timing
solenoid valve
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
D range B+
2H ———— —
2I ———— —
2J CAN L PCM Because this
terminal is for serial
communication,
good/no good
judgment by
terminal voltage is
not possible. Carry
out inspection
according to DTCs.
— • Inspect related harness
2K ———— —
2M CAN H PCM Because this
terminal is for serial
communication,
good/no good
judgment by
terminal voltage is
not possible. Carry
out inspection
according to DTCs.
— • Inspect related harness
2N ———— —
2P GND return
(solenoid ground)
Solenoid valve Constant Continuity • Inspect related harness
2Q ———— —
2S TCC solenoid valve
control
TCC solenoid valve D range TCC ON
(60 km/h {37 mph}
or more)
B+ • Inspect TCC solenoid
valve
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
TCC released (M
range, 1GR—4GR)
0
2T Shift solenoid B
control
Shift solenoid B N position B+ • Inspect shift solenoid B
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
D range, 4GR gear 0
2U High clutch
solenoid valve
High clutch
solenoid valve
N position 0 • Inspect high clutch duty
solenoid valve
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
When shifting 1-2 in
D range
B+
2V 2-4 Brake solenoid
valve
2-4 Brake duty
solenoid valve
N position B+ • Inspect 2-4 Brake
solenoid valve
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
D position stall 0
2W Shift solenoid A Shift solenoid A N position B+ • Inspect shift solenoid A
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
D range, 3GR gear 0
2X Shift solenoid C
control
Shift solenoid C N position B+ • Inspect shift solenoid C
(See K2–88 SOLENOID
VALVE INSPECTION)
• Inspect related harness
D range 0
Terminal Signal Connected to Test Condition Voltage (V) Action
To Next Page