CYLINDER HEAD GASKET
B2–21
B2
Fuel Injection Pipe Installation Note
Caution
• Fuel injection pipes can be removed and reinstalled up to five times. If removing them for the sixth
time, be sure to replace them with new ones.
Cylinder Head Cover Installation Note
1. Apply silicone sealant to the shaded areas.
Thickness
2 mm {0.079 in}
2. Tighten the bolts in the order shown.
Tightening torque
7.9—10.7 N·m {80—110 kgf·cm, 69.5—95.4
in·lbf}
Seal Plate Installation Note
1. Install the seal plate and hand tighten the bolt in
the order A to B.
2. Tighten the bolts in the order shown.
Tightening torque
7.9—10.7 N·m {80—110 kgf·cm, 69.5—95.4
in·lbf}
Idler Installation Note
Caution
• The idler has a front and back relative to
the engine, therefore when installing
make sure that the longer projection of
the shaft is on the engine side as
indicated in the figure.
SEALANT
SEALANT
SEALANT
20 mm
{0.79 in}
MIN.
VIEW A
VIEW A
A6E2318W116
9
8
7
5
4
3 6
1
2
A6E2318W117
1
2
B
A
3
3
A6E2318W118
SHAFT
CYLINDER
BLOCK
BOLT
A6E2318W121
To Next Page
Loading...
