PROPELLER SHAFT
L–9
L
Snap Ring Disassembly Note
1. Mark the yoke and flont propeller shaft or york
and rear propeller shaft for proper reassembly.
2. Clamp the propeller shaft in a vise.
3. Remove the snap ring using a screwdriver.
Bearing Cup Disassembly Note
1. Use a copper hammer to loosen the propeller
shaft bearing cup, then remove the bearing cup.
2. Remove the opposite bearing cup in the same
manner.
3. Separate the propeller shaft and yoke.
4. Clamp the yoke in a vise.
5. Remove the bearing cups and the spider from the
yoke as in Step 1 and 2.
Locknut Disassembly Note
1. Mark the center yoke and center propeller shaft
for proper reassembly.
2. Clamp the center yoke in a vice.
3. Remove the locknut and spring washer.
MARK
A6E6110W004
YTA6110W107
YTA6110W108
MARK
A6E6110W005
To Next Page