M–18
OUTLINE
SUPPLEMENTAL SERVICE INFORMATION
A6E630201018204
• The following additions have been made since publication of the Mazda6 Workshop Manual (1730-1*-02C).
Rear wheel hub bolt
• Replacement procedure has been added.
Wheel hub, knuckle
• Removal/installation procedure has been added.
Joint shaft (MZR-CD (RF Turbo))
• Disassembly/assembly procedure has been added.
Joint shaft (4WD)
• Disassembly/assembly procedure has been added.
Front drive shaft (MZR-CD (RF Turbo))
• Disassembly/assembly procedure has been added.
Front drive shaft (4WD)
• Disassembly/assembly procedure has been added.
Rear drive shaft
• Inspection procedure has been added.
• Removal/installation procedure has been added.
• Disassembly/assembly procedure has been added.
Differential oil
• Inspection procedure has been added.
• Replacement procedure has been added.
Oil seal (side gear)
• Replacement procedure has been added.
Oil seal (companion flange)
• Replacement procedure has been added.
Rear differential
• Removal/installation procedure has been added.
• Disassembly procedure has been added.
• Assembly procedure has been added.
Differential oil temperature sensor
• Inspection procedure has been added.
• Removal/installation procedure has been added.
4WD solenoid
• Inspection procedure has been added.
Coupling component
• Removal/installation procedure has been added.
• Disassembly procedure has been added.
• Assembly procedure has been added.
On-board diagnostic
• Electronic 4WD control system have been added.
Troubleshooting
• Electronic 4WD control system have been added.
End Of Sie
OUTLINE
To Next Page
Loading...
