R–18
REAR SUSPENSION
Crossmember component, Differential And Drive Shaft Removal Note
1. Support the differential with a jack, and remove
the nut.
Warning
• Removing the crossmember component,
differential and drive shaft is dangerous.
The crossmember component,
differential and drive shaft could fall and
cause serious injury or death. Verify that
the jack securely supports the differential
lower side.
2. Remove the crossmember component,
differential and drive shaft.
Rear Crossmember Bushing Removal Note
1. Remove the bushing using a screw driver (-),
being careful not to damage the rear
crossmember.
Rear Crossmember Bushing Installation Note
1. Set the bushings as shown in the figure.
JACK
A6E74162012
A6E7416W001
A
B
D
C
A
B
C,D
FRONT
UPPER SIDE
LOWER SIDE
OVAL
HOLE
CROSS-
SECTIONAL
VIEW
A6E74162014
To Next Page