10. Hold the heated body with the valve pin facing downwards towards the
nozzle. Position the piston assembly so that the valve pin holder slot is
also facing downwards towards the nozzle. Slide the piston assembly
over the heated body and seat the valve pin holder into the piston top slot.
See Figure 11-12 and Figure 11-13.
Figure 11-12 Install piston assembly onto heated body
Figure 11-13 Overhead view of seated piston assembly
Assembly - continued
11-9SLIMSTACK ACTUATOR
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
To Next Page
