8. Insert the dowel pin into the outer cylinder assembly.
9. Use your ngers to gently push the O-rings into the outer grooves in the
cylinder. Make sure that the O-rings sit rmly in the grooves.
10. Apply grease to the O-ring assembly groove in the outer surface of the
cylinder top.
11. Use your ngers to gently push the O-ring into the outer groove of the
cylinder top. Make sure that the O-ring sits rmly in the groove.
17-15ACCU-LINE™
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
To Next Page
