Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 119
___________________________________________________________________________________
___________________________________________________________________________________
LED 5 ICGA Live LED flashes every 125 ms during normal
operation.
LED 6 SHUTDOWN
Switch
Indicates that the switch has no software control.
On red only when SHUTDOWN switch is in RUN.
LED 7 Shutdown On red when Switch S3 is in SHUTDOWN to
indicate that voice mail can be safely removed form
the KSU.
LED 8 Power On red when ETU is receiving power from the KSU.
LED 9 FED DSP Used only for development purposes.
LED 10 CH 1 On red when voice channel 1 is Off Hook.
LED 11 CH 2 On red when voice channel 2 is Off Hook.
LED 12 CH 3 On red when voice channel 3 is Off Hook.
LED 13 CH 4 On red when voice channel 4 is Off Hook.
LED 14 CH 5 On red when voice channel 5 is Off Hook.
LED 15 CH 6 On red when voice channel 6 is Off Hook.
LED 16 CH 7 On red when voice channel 7 is Off Hook.
LED 17 CH 8 On red when voice channel 8 is Off Hook.
The first four channel LEDs are also used during startup to show that
the BICOM driver is loaded (LED 1), Scan disk successfully com-
pleted (LED 2), CoSession Host successfully Loaded (LED 3), and
voice mail started successfully (LED 4). After the system is up and
running and all channels are ready to receive calls, these LEDs are
Off. When voice mail does not start successfully, all eight
channel LEDs and LED 1 are On.
Table 6-41 FMS-U30 ETU LED Indications (Continued)
LED Name Description
To Next Page
Loading...
