NEC ELECTRA ELITE IPK II - Page 495

Electra Elite IPK II Document Revision 3
System Hardware Manual 10 - 15
___________________________________________________________________________________
___________________________________________________________________________________
SECTION 7REMOVING DTU/DTP SOFTKEYS
When the softkeys on the Multiline Terminal are not used, they can be removed using
the following procedure:
1. Remove the softkeys by pulling the softkey plate upward as shown in
Figure 10-17 Removing DTU/DTP Softkeys.
SECTION 8ADJUSTING DTU/DTP MULTILINE TERMINAL HEIGHT
The base plate on the Electra Elite Multiline Terminal is hinged to allow adjustment to
raise or lower the terminal.
1. Turn the Multiline Terminal upside down and locate the tabs as shown in Figure
10-18 Locating the Adjustment Tabs on the DTU/DTP Multiline Terminal.
Figure 10-17 Removing DTU/DTP Softkeys
Figure 10-18 Locating the Adjustment Tabs on the DTU/DTP Multiline Terminal