NEC ELECTRA ELITE IPK II - Page 508

___________________________________________________________________________________
11 - 4 Installing Electra Elite Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
6. When an adapter is being installed, press tabs A and B to remove the dummy
end from the base plate as shown in Figure 11-5 Removing Base Plate Dummy
End.
7. Cut the dummy end in half as shown in Figure 11-6 Cutting Dummy End in Half.
8. When the adapter is installed in connector 1 as shown in Figure 11-7 Installing
Adapter in Connector 1, Install the dummy end B as shown in Figure 11-8
Installing Dummy End B.
Figure 11-5 Removing Base Plate Dummy End
Figure 11-6 Cutting Dummy End in Half