4
Scan to E-Mail
4-10 VarioLink 2221/2821/3621
Specifying chain dialing
If the destination address is longer than 64 characters, the address can be
specified by combining addresses registered to one-touch dial buttons and
an entered address.
Touch [Chain], and then select one-touch dial buttons or enter an address.
Detail
Chain dialing can only be used with one
destination per transmission.
With chain dialing, the address can
contain up to 192 digits (64 characters
from a one-touch dial button + 64
characters from a one-touch dial
button + 64 characters from an entered
address).
The one-touch dial buttons to be used with chain dialing must be
programmed in advance.
To Next Page
Loading...
