Oce VarioLink 2221 - Specifying Software Switch Settings (Machine Functions); Software Switch Settings

10
Specifying management settings
10-28 VarioLink 2221/2821/3621
10.8 Specifying software switch settings (machine
functions)
By using the software switch settings, the mode, bit, and HEX values of each
function of the machine can be changed from the factory settings to meet
your specific needs.
2
Reminder
Do not change any modes or bits other than those described in this
manual.
2
Note
When "Enhance Security" is set to "ON", the software switch settings
cannot be changed.
Software switch settings
Item Description
Mode Selection Parameters to be specified are represented by a three-digit
number. Type in the value using the keypad.
Bit Selection A mode status is expressed with an eight-digit number. By
specifying a binary number (1 or 0) for each of the bits 0 through
7, a setting can be specified for each parameter.
HEX Selection The settings of each mode are expressed using hexadecimal
numbers (combinations of 0-9 and A-F). The bit selection
"00110000" equals the HEX selection "30".
Specify mode settings either with bit or hexadecimal selections.