Oce VarioLink 2221 - LDAP (Administrator Mode); Specifying the LDAP Settings

9
Specifying settings using Web Connection
9-70 VarioLink 2221/2821/3621
9.16 LDAP (Administrator mode)
The settings used by the LDAP (Lightweight Directory Access Protocol)
server in a network can be specified.
Settings can be specified for the following.
Specifying the LDAP settings
1 In the Administrator mode, click the Network tab.
– For the procedure to log on to Administrator mode, refer to
"Logging on to Administrator mode" on page 9-11.
2 Click [Common Setting], then [LDAP].
3 Select whether to enable or disable LDAP searches, and then click
[Apply].
Item Description
LDAP Select whether to enable or disable address searches where the LDAP server
is used. If "Enable" is selected, the LDAP server can be specified.
Search Default
Setting
Select which of the registered LDAP servers is to be accessed. This parame-
ter appears if an LDAP server has been registered.