Oce VarioLink 2221 - Specifying the Address of the Forwarding Destination

Specifying settings using Web Connection
9
VarioLink 2221/2821/3621 9-57
Specifying the address of the forwarding destination
1 In the Administrator mode, click the Scan tab.
– If the optional fax kit has been installed, click the Fax/Scan tab.
– For the procedure to log on to Administrator mode, refer to
"Logging on to Administrator mode" on page 9-11.
2 Click [TX Document].
3 Select the address of the forwarding destination. Click [Select
Forwarding Destination].
The list of one-touch dial destinations appears.
4 Select the address of the forwarding destination, and then click [Apply].
– Only one address can be selected.
5 Click [Apply].